Watchguard V2 Specifikace stáhnout pdf (Strana 27)

Installing the Siren Unit

Figure 10

1. Drill mounting holes (7mm diameter, 25mm

minimum in depth) into the chosen wall.

2. If a masonry wall, use the green star plugs.

Press each one into the 4 main mounting holes.

3. Make a 12mm hole and feed the 10m of low

voltage power cable through the wall and up

into the ceiling for power.

4. Screw the top 2 screws half way in.

5. Place the unit to support itself from the top 2

screws through the key shape holes at the top

of the main control unit

6. Screw in and tighten the bottom two mounting

screws then tighten the top two screws.

7. Now run the 10m of low voltage cable through

the roof to the closest power point.

8. Plug the power adapter into your power point,

connect the 10m cable, and then turn the power

point on.

9. Now turn the key switch on the outdoor siren to

the ON position (clockwise).

10. Perform Wireless Siren Auto Test.

Note: If for any reason your external siren does not beep when you arm & disarm your

Watchguard Digital, simply turn off the External Siren Key switch, wait for 10 seconds and

then turn back on again. Now immediately (within 3 seconds) arm the system using your

remote control. You should now hear 1 beep from the external siren.

Figure

Plug on power adapter Socket on 10m of

connected to power point cable from the siren

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 55 56

Žádné komentáře

Watchguard V2 Specifikace Strana 27